If you want to reformat the storage device that is installed/connected to your Stream+, please see the following instruction or, you can perform a Factory Data Reset
- Press the Home button on your remote.
- Navigate down to Settings and select it.
- Navigate down to Storage and Reset and select it.
- Highlight your [name of your storage device] and select it.
- Highlight and select Eject, then again Eject.
- The next screen is [name of your storage device] drive removed and select ok.
- Physically remove the storage device.
- Press the Home button on your remote.
- Select Storage and reset.
- Select the [name of your storage device].
- Select Forget this device storage.
- Select Forget.
- Select Home button on remote.
- Re-install/connect your storage device.
- Choose Setup as OTA Storage.
- Select Format.
- While it completes the Formatting USB Drive, you'll see a brief message saying USB drive Reconnected.
- Next screen is Moving data to [your storage device name] drive.
- You will briefly see a message "USB drive is formatted."
- You will briefly see a message, "Migrated data to [storage device name] USB drive."
- You can now operate normally.
If there were programs/recordings on the storage device that was replaced, those recordings will still appear to be available.
- If you select those recordings, you will just see a black screen.
- You will need to delete those old recording titles.
Deleting Previous Recordings/Programs
- Press the DVR button on your remote.
- Press the left arrow to see the Blue Category Banner.
- Navigate down, past Series.
- You can now see rows of the previous recordings.
- Select the first program to delete, and a blue message appears.
- Navigate right to Delete Recordings and select it.
- On the next screen, highlight Select all episodes and press the OK button.
- You'll now see a √check mark next to all episodes listed there.
- Navigate right, and select Delete.
- That Program Title tile will no longer be in the row.
- Repeat this for all other Title tiles for previous recordings.