How do I connect my Stream+ to the network internet via WPS mode on my router? (CM-7600 CM7600)

WPS is a WIFI protocol/Standard, available to easily connect the Stream+ to a WIFI Router without needing Pass Phrases/Passwords. (WPS = WIFI Protected Setup.) Most WIFI routers will have a WPS button. It could be labeled 'WPS' or it could be an icon of the manufacturer's choice. Consult your WIFI router User Guide if you are not sure. 

  • Press the Home button on your remote control.
  • Navigate down to Settings and select it.
  • Select 'Network'.
  • Navigate down to  'Connect via WPS' and select.
  • You will see a message on the screen, 'Searching for WPS Router...'
  • It will also prompt you to 'Press the WPS button on your router...' Consult your User Guide. You may need to 'press and hold' the button or 'press and release' the button.
  • When the Stream+ has located the WIFI router that is in 'WPS mode' you'll see 'Obtaining IP Address'.
  • Then you should see 'Connected Successfully'. 
  • Now in the 'Network' settings, you should see the name of your WIFI router with 'Connected' under that name. 
  • To check the WIFI signal strength, highlight your router and select it. 
  • 4 lines down you'll see 'Signal Strength' and you should see "Excellent" under that.
  • If it is not 'Excellent', you can try moving your Stream+ higher, or away from other electronics. You can also try to reorient the position of your WIFI router. 
  • You can now press the Home button on your remote and begin using your Stream+.
Have more questions? Submit a request