Stream+ Remote pairing via Bluetooth. (CM-7600)

If you missed the remote control portion in the Setup Wizard, or if your 2x AAA, remote control batteries go dead, you'll need to pair the remote to the Stream+ via Bluetooth. 

Pair the Stream+ Remote via Bluetooth

  1. Point your remote at the Stream+ and press the Home button.
  2. Navigate down to Settings and select it by pressing the OK button. 
  3. Navigate down to Bluetooth and select it.
  4. Make sure the switch is Green. If not, press OK to turn Bluetooth on.
  5. Press the back button on your remote. 
    1. You'll now be back to Settings menu.
  6. Navigate down to Add Accessory and select it. 
  7. It will start searching for Bluetooth devices/accessories. 
  8. Press and hold, both the Home button, and the OK buttons on your remote.
    1. This places the remote in pairing mode and the red light on the remote will begin blinking.
    2. You can let go of the two buttons when the red light on the remote stays solid red.
  9. Keep the remote control close to the Stream+ until you see Channel Master Remote on the top/right of the screen.
  10. Point the remote at the Stream+ and press the OK button on the remote.
  11. Within a few moments it will say Pairing under Channel Master Remote.
  12. After a few more moments, it will say Connecting.
  13. After a certain amount of time, (~10 to ~60 seconds.) it will say Paired under Channel Master Remote on the upper screen and Connected on the bottom of the screen. 
  14. You should now be able to control the Stream+ normally, without pointing the remote at the Stream+.
  15. Press the Home button to exit the Settings Menu and return to the home screen. 
Have more questions? Submit a request