Follow this procedure to program the INPUT button on the DVR+ Remote (CM-7500XRC2) to control your audio device’s inputs instead of controlling your TV’s inputs.
Note: Before following this procedure, you must first program your remote to control your audio device, as described on the previous pages in this section.
1 Press and hold the setup button until the on/off button blinks twice, then release the button.
2 Press and release the input button.
3 Press and release the green (aud) button. The Power On/Off button will blink twice to indicate that the programming has been changed.
Note; If you wish to revert input control back to your TV, repeat this procedure and press the red (TV) button instead of the green (aud) button in step 3.